Adding Nodes For An Ethernet Wan Configuration; Ultranet Configmanager Main Window - McDATA ULTRANETTM EDGE STORAGE ROUTER 3000 User Manual

Configuring a 2x2 Ethernet Wide Area Network
6
Adding Nodes for
an Ethernet WAN
Configuration
McDATA UltraNet Edge 3000 User Guide
6-4
Tree
View
Area

UltraNet ConfigManager Main Window

Figure 6-2
Use the following procedures to create a sample network map for a
2x2 Gigabit Ethernet WAN configuration. This configuration will
have two nodes that extend two Fibre Channel Switch (FCSW)
interfaces over two Gigabit Ethernet WANs.
NOTE: When configuring a 2x2, the Ethernet Maintenance Interface and both
WAN interfaces must be on separate subnets.
1. Select the Nodes tab located on the toolbar between the
TreeView Area and the Network Map Area.
The Nodes tab displays three drop-down menus, containing the
node types for each available UltraNet Edge Series.
Network
Map
Area