Adding An Ip Circuit - McDATA ULTRANETTM EDGE STORAGE ROUTER 3000 User Manual

Configuring a 2x2 Ethernet Wide Area Network
6

Adding an IP Circuit

McDATA UltraNet Edge 3000 User Guide
6-12
4. Click the Finish button to complete the configuration.
5. Right-click on Node 20 and then repeat step 1 through step 4 to
set the licensing information for this node.
6. Continue the configuration process by proceeding to the "Adding
an IP Circuit" procedure.
You will now create an IP circuit. A circuit is the IP WAN link
between Node10 and Node20. Use the IP Circuit Wizard to create
and configure the IP circuit by using the following procedure:
1. Select the Links tab on the center toolbar.