Issuing The Spantree Portfast Command - McDATA ULTRANETTM EDGE STORAGE ROUTER 3000 User Manual

Issuing the Spantree Portfast Command

This appendix provides information about the spantree portfast
command for Cisco routers.
When a WAN link goes down and comes back up quickly, the virtual
circuit may take from 30 to 90 seconds to re-establish itself. The
spantree portfast
directly connected to the UltraNet Edge 3000 to recover faster.
Issue the
spantree portfast
for the UltraNet Edge 3000 is necessary.
NOTE: The information contained in the following section was obtained
from Cisco Customer Support.
set spantree portfast [mod_num/port_num] [enable|disable]
where:
mod_num
port_num
enable
disable
Using the Spantree
Portfast Command for
command allows the Cisco router port that is
command only when faster recovery
Number of the module.
Number of the port on the module
Enables the spanning-tree port fast-start feature on the port.
Disables the spanning-tree port fast-start feature on the port.
By default the port fast-start feature is disabled.
I
Cisco Routers
I-1