McDATA ULTRANETTM EDGE STORAGE ROUTER 3000 User Manual page 214

Network Configuration Examples
9
Rules for Static LUN
World Wide Name
McDATA UltraNet Edge 3000 User Guide
9-6
Static LUN mapping turns off automatic LUN discovery to the
Mapping
remote target. If any LUNs are statically configured to a remote
target, then all LUNs which are to be accessed on that target must be
statically mapped.
A statically mapped LUN cannot be purged with the user interface
wwnPurg
from the configuration first. See the "Basic Troubleshooting Steps for
FC/SCSI Tape Pipelining" section in Chapter 13.
Table 8-3 shows a fictitious World Wide Name (WWN) for each
Table
device. These WWNs are used in the static LUN mapping examples
shown in Table 8-4 and Table 8-5 (page -7).
Table 9-3
command. The statically mapped LUN must be removed
Fictitious WWNs for Devices shown in Figure 8-3
Device Type
Server A
Server B
Server C
Tape A1
Tape A2
Tape B1
Tape B2
Tape C1
Tape C2
Tape C3
Tape C4
Media Changer 1
Media Changer 2
WWN
AA:AA:AA:AA:AA:AA:AA
BB:BB:BB:BB:BB:BB:BB:BB
CC:CC:CC:CC:CC:CC:CC:CC
A1:A1:A1:A1:A1:A1:A1:A1
A2:A2:A2:A2:A2:A2:A2:A2
B1:B1:B1:B1:B1:B1:B1:B1
B2:B2:B2:B2:B2:B2:B2:B2
C1:C1:C1:C1:C1:C1:C1:C1
C2:C2:C2:C2:C2:C2:C2:C2
C3:C3:C3:C3:C3:C3:C3:C3
C4:C4:C4:C4:C4:C4:C4:C4
FF:01:FF:01:FF:01:FF:01
FF:02:FF:02:FF:02:FF:02