McDATA ULTRANETTM EDGE STORAGE ROUTER 3000 User Manual page 235

Right-click on the FC interface
Double-click
FC interface
1. In the main window of the UltraNet ConfigManager, right-click
on the Fibre Channel Device Extension
Node10 in the network map.
The Create Data Path menu is displayed.
2. Click the Create Data Paths selection. You should see "marching
ants" outlining the Fibre Channel Device Extension.
3. Double-click on the destination Fibre Channel Device Extension
interface 20 on Node 20 in the network map.
The FC Device Extension DataPath Wizard - Introduction dialog
box appears.
The FC Device Extension DataPath wizard collects information to
create data paths between selected interfaces.
Configuring Tape Device Extension
interface 10 for
Configuring Tape Device Extension
9
9-27