Charging Assembly; Outline; Removing The Primary Charging Assembly; Removing The Grid Plate - Canon 1130 Service Manual

C. Charging Assembly

1. Outline

The copier has five charging assemblies
equipped with charging wires, each of which
is 0.06 mm in diameter.
2. Removing the Primary Charging

Assembly

1) Open the hopper unit fully.
2) Disconnect the connector [1], and remove
the screw [2]; then, detach the primary

charging assembly [3].

3. Removing the Grid Plate

1) Remove the primary charging assembly.
2) Remove the screw [1], and remove the
grid plate [2].
COPYRIGHT © 2002 CANON INC. CANON CLC1100/1130/1150/1160/1180 REV.1 JAN. 2000 PRINTED IN JAPAN (IMPRIME AU JAPON)
CHAPTER 6 IMAGE FORMATION SYSTEM
[2]
Figure 6-621
[2]
Figure 6-622
[1]
[3]
[1]
6-61