If you have replaced the paper level detecting VR or initialized the RAM, you must enter the
factory values recorded on the service label in service mode:
ADJUST>CST-ADJ>C1-LVOL
Use it to enter the slice level of paper volume for cassette 1 (for 50 sheets)
ADJUST>CST-ADJ>C1-HVOL
Use it to enter the slice level of paper volume for cassette 1 (for 275 sheets)
ADJUST>CST-ADJ>C2-LVOL
Use it to enter the slice level of paper volume for cassette 2 (for 50 sheets)
ADJUST>CST-ADJ>C2-HVOL
Use it to enter the slice level of paper volume for cassette 2 (for 275 sheets)
ADJUST>CST-ADJ>C3-LVOL
Use it to enter the slice level of paper volume for cassette 3 (for 50 sheets)
ADJUST>CST-ADJ>C3-HVOL
Use it to enter the slice level of paper volume for cassette 3 (for 275 sheets)
C. Detecting the Paper Size Inside the Cassette
1. Fixed-Size Type Cassette
The fixed-size cassette of each model (Table 7-202) is not equipped with a function to detect
paper size, and its size is switched by the service person as follows:
1) Change the paper guide plate inside the cassette to suit the paper size specified by the user.
2) Enter the new paper size in service mode:
OPTION>CST>P-SZ-C1
Use it to set the paper size for cassette 1.
OPTION>CST>P-SZ-C
Use it to set the paper size for cassette 2.
2. Universal Type Cassette
a. To detect the length of paper, the copier uses a paper length sensor consisting of two
photointerrupers.
b. To detect the width of paper, the copier uses a paper width detecting volume.
Part 2>Chapter 6>2.1.3>b
Paper size detection
Paper length sensor
Paper width detecting volume
COPYRIGHT © 2002 CANON INC.
Cassette
Table 7-205
CANON CLC1100/1130/1150/1160/1180 REV.2 FEB. 2002 PRINTED IN JAPAN (IMPRIME AU JAPON)
CHAPTER 7 PICK-UP / FEEDING SYSTEM
Cassette 2
Cassette 3
PSU2/DSU3
PSU3
VR3/DVR5
VR5
7-11