Canon 1130 Service Manual page 485

CHAPTER 10 PAPER DECK
4) Remove the compartment.
5) Remove the screw [3], and detach the
sensor covers upper and lower [4].
6) Disconnect the four connectors [5], and
remove the six screws [6]; then, detach the
metal plate [7].
7) Insert a hex wrench [9] or the like into the
hole of the lifter drive shaft [8] to hold it in
position (against turning).
If the lifter drive shaft is not
held
instructed, the lifer cable
will become slack when the
lifter
removed. Take full care.
10-32
COPYRIGHT © 2002 CANON INC.
in position as
motor unit is
CANON CLC1100/1130/1150/1160/1180 REV.1 FEB. 2002 PRINTED IN JAPAN (IMPRIME AU JAPON)
[4]
Figure 10-332
[6]
Figure 10-333
[8]
Figure 10-334
[3]
[6]
[6]
[7]
[6]
[5]
[9]
(front)