Canon 1130 Service Manual page 518

8) Supply M, C, and Y starter developers by
repeating steps 1) through 6). (Press
SPLY-M, SPLY-C,
accordingly.)
9) Turn the hopper unit slowly, and push
down the hopper stopper so that the roll on
the left of the hopper is pushed as far as
the first click is felt.
Here, do NOT push in the hopper unit to
lock it in position as yet.
1. Take extra care; pushing
2. Do no handle the hopper
10) Press 'STIR-4'.
Be sure to wait until the
copier indicates 'READY'
on its control panel before
executing
service mode.
11) Press 'OI', and wait until stirring ends
(about 10 min).
12) Press 'INIT-4'.
Wait until the copier
indicates 'READY' on its
control
executing 'INIT-4' in
service mode.
COPYRIGHT © 2002 CANON INC.
or SPLY-Y
in the hopper unit all the
way to its locking
position at the rear will
damage the hopper by
the hopper plug.
unit roughly. Otherwise,
large amounts of toner
will drop from the
hopper assembly.
STIR-4
panel before
CANON CLC1100/1130/1150/1160/1180 REV.2 FEB. 2002 PRINTED IN JAPAN (IMPRIME AU JAPON)
in
CHAPTER 11 INSTALLATION
11-21