Canon 1130 Service Manual page 609

CHAPTER 13 TROUBLESHOOTING
9) Press the Reset key, and turn off the power switch.
10) Disconnect the connector J1 of the environment measurement PCB.
11) Turn on the power switch.
12) Check the temperature and the humidity on the DISPLAY>ANALOG screen in service mode.
TEMP: 25 ±5°C
ABS-HUM: 36 ±10%
13) Check to see that the reading is as indicated.
If not, suspect a fault on the DC driver PCB or the CPU PCB.
14) Press the Reset key.
15) Turn off the power switch.
16) Connect the connector J1 to the environment measurement PCB.
17) Detach the environment measurement PCB checker from the environment measurement PCB,
and connect the environment sensor in its place.
18) Attach all covers.
b. Checking the Environment Sensor
1) Check the environment measurement PCB.
2) Turn on the power switch, and leave the copier alone for 5 min.
3) Check the temperature and the humidity on the DISPLAY>ANALOG screen in service mode,
and record the readings. (data A)
TEMP: °C
ABS-HUM: %
4) Press the Reset key, and turn off the power switch.
5) Detach the environment sensor from the environment measurement PCB, and insert the
environment sensor calibration tool (TKN-0456) in its place.
6) Turn on the power switch, and leave the copier alone for 5 min.
7) Check the temperature and the humidity on the DISPLAY>ANALOG screen in service mode,
and take notes of them.
TEMP: °C
ABS-HUM: %
8) Compare data A and data B.
• difference between data A1 and data B1 is 0 ± 5.
• difference between data A2 and data B2 is 0 ± 20
If the difference between data A and data B is not as indicated, replace the environment sensor.
9) Press the Reset key, and turn off the power switch.
10) Detach the environment sensor calibrating tool from the environment measurement PCB, and
fit the environment sensor.
11) Mount all covers.
The environment sensor calibration tool (TN-0456) is adjusted at the factory to
high precision. Be sure to store it in an airtight container with a drying agent for
storage.
13-40
COPYRIGHT © 2002 CANON INC.
data A1
data A2
data B1
data B2
CANON CLC1100/1130/1150/1160/1180 REV.1 FEB. 2002 PRINTED IN JAPAN (IMPRIME AU JAPON)