Developing Assemblies; Construction Of The Y/M/C Developing Assembly; Construction Of The Bk Developing Assembly; Removing The Developing Assembly - Canon 1130 Service Manual

CHAPTER 6 IMAGE FORMATION SYSTEM
D. Developing Assemblies
1. Construction of the Y/M/C
Developing Assembly
[1] Developing cylinder
[2] ATR sensor
2. Construction of the Bk Developing
Assembly
[1] Developing cylinder
3. Removing the Developing
Assembly
1) Open the right front cover.
2) Remove the two screws, and detach the
hopper stopper plate; then, open the
hopper fully.
3) Remove the Y/M/C developing assembly.
Remove the screw [1], and disconnect the
connector [2]; then, pull out the
developing assembly slowly.
4) Remove the Bk developing assembly.
Remove the screw [3], and pull out the
developing assembly.
6-64
COPYRIGHT © 2002 CANON INC. CANON CLC1100/1130/1150/1160/1180 REV.1 JAN. 2000 PRINTED IN JAPAN (IMPRIME AU JAPON)
[1]
Figure 6-627
[1]
Figure 6-628
[3] [1]
Figure 6-629
[2]
[1]
[2]
[1]
[2]
[2]