Canon 1130 Service Manual page 742

7 Duplexing Unit/Re-Pickup Assembly
Cause
Duplexing unit
Paper
Duplexing
reversing roller
Duplexing paper
feed roller
Paper sensor
(duplexing tray
assembly)
Paper jogging
guide plate
Stopper plate
Duplexing driver
PCB,
clutch
Duplexing paper
feed roller
Duplexing
separation roller
Duplexing feed
roller
COPYRIGHT © 2002 CANON INC.
Step Checks
1 Is the duplexing unit set in the
copier correctly?
2 Try paper of a type recommended
by Canon.
3 Is the duplexing reversing roller
deformed or soiled?
4 Is the jam around the duplexing
feed roller area?
5 Is the paper sensor (PS35, PS36) of
the duplexing tray assembly
operating normally?
6 Is the paper jogging guide plate
operating normally?
7 Is the stopper plate operating
normally?
8 Does the duplexing paper feed
roller rotate?
9 Is the duplexing paper feed roller
deformed or worn?
10 Is the duplexing separation roller
deformed or worn?
11 Is the duplexing feed roller
deformed or worn?
CANON CLC1100/1130/1150/1160/1180 REV.1 FEB. 2002 PRINTED IN JAPAN (IMPRIME AU JAPON)
CHAPTER 13 TROUBLESHOOTING
Yes/No
NO Set the duplexing unit
correctly. Check to
make sure that there is
no foreign matter inside
the unit.
YES Advise the user to use
recommended paper.
YES Replace the duplexing
reversing roller.
YES Check the duplexing
paper feed roller
solenoid (SL13).
NO Check the lever and
wiring; if normal,
replace the sensor.
YES Check the paper jogging
guide motor (PM14); if
normal, replace the
home position sensor
(PS40).
NO Check the stopper plate
solenoid (SL12).
NO See IV.
NO Replace the duplexing
paper feed roller.
NO Replace the duplexing
separation roller.
YES Replace the duplexing
feed roller.
NO Check each paper plate
or duplexing tray
assembly for foreign
matter and deformation.
Action
49.
13-159