CHAPTER 9 EXTERNALS / AUXILIARY MECHANISMS
H. Main Motor (M4) Drive
Assembly
1. Removing the Main Motor (M4)
1) Remove the rear over.
2) Remove the flywheel.
3) Open the CPU PCB.
4) Remove the back suction fan [1].
5) Remove the six screws [2], and detach the
drive assembly reinforcing plate [3].
6) While lifting the tension plate [4] by hand,
detach the drive belt 1 [5].
7) Disconnect the two connectors [6], and
remove the five screws [7]; then, detach
the main motor assembly [8] together
with the mounting plate.
8) Remove the clamp of the motor output
shaft, and remove the four screws; then,
detach the main motor from the mounting
plate.
9-32
COPYRIGHT © 2002 CANON INC.
CANON CLC1100/1130/1150/1160/1180 REV.1 JAN. 2000 PRINTED IN JAPAN (IMPRIME AU JAPON)
[2]
[2]
[2]
[3]
Figure 9-735
[4]
Figure 9-736
[7]
[8]
[7]
Figure 9-737
[1]
[2]
[5]
[7]
[6]
[7]