Removing The Lifter Cable - Canon 1130 Service Manual

CHAPTER 10 PAPER DECK
4. Removing the Lifter Cable (front of
the deck)
1) Open the compartment of the deck, and
remove all paper.
2) Remove the screw, and detach the paper
rear guide plate from the inside of the
compartment.
3) Push down the sensor lever [1] of the
paper supply position inside the
compartment to lower the lifter so that the
holes in the left and right of the
compartment side plate and the holes in
the left and right of the lifter match; then,
insert two long screwdrivers [2] through
the holes (to position the lifter). At this
time, try matching the top face of the lifter
against the scribe line on the compartment
left plate to facilitate the work.
4) Remove the front cover of the deck.
5) Remove the four screws [3], and detach
the roll support plate [4].
10-30
COPYRIGHT © 2002 CANON INC. CANON CLC1100/1130/1150/1160/1180 REV.1 FEB. 2002 PRINTED IN JAPAN (IMPRIME AU JAPON)
[1]
[2]
Figure 10-328
[4]
Figure 10-329
[3]