Canon 1130 Service Manual page 234

11) Remove the gear [23].
12) Shift the bearings [24] found on both ends of
the developing cylinder in the direction of
the arrow, and pull off the cylinder [25].
While butting the bearing
against the wall X
case, force the sleeve in the
direction of Y and mount
the grip ring Z
sure there is no gap.
In this condition, butt the
opposite bearing against
the wall X
mount the grip ring so that
the gap between the roll
and the washer is 0.2 ±0.1
mm.
COPYRIGHT © 2002 CANON INC.
of the
1
, making
1
of the case, and
2
CANON CLC1100/1130/1150/1160/1180 REV.2 FEB. 2002 PRINTED IN JAPAN (IMPRIME AU JAPON)
CHAPTER 6 IMAGE FORMATION SYSTEM
Figure 6-643
[24]
Figure 6-644
X 1 Y
Z 1
Figure 6-645
[23]
[25]
X 2
0.2 0.1mm
6-69