Canon 1130 Service Manual page 246

4) Remove the five screws [5], and detach
the photosensitive drum cleaner blade.
• When mounting the Photosensitive
Drum Cleaner Blade
5) By matching against the positioning hole
of the photosensitive drum cleaning
blade, fit the 5 screws [5] in the sequence
indicated in the illustration (i.e., by
following a specific direction).
6) Fit the screw [3] (one each), and mount
the end seal [4].
• When mounting the blade, note that using the wrong sequence to attach the
end seal and the fixing screws can cause the middle of the blade to warp,
ultimately causing cleaning faults. Fitting the fixing screws of the blade
starting at the rear and the moving toward the front and the attachment of the
end seal serve to ensure that the blade will not warp later.
• If the amount of drum cleaner lubricant on the blade is not adequate, be sure
to apply a good amount before mounting it.
• If toner is found where the blade is to be mounted, be sure to remove it before
starting the mounting work.
COPYRIGHT © 2002 CANON INC. CANON CLC1100/1130/1150/1160/1180 REV.0 FEB. 2002 PRINTED IN JAPAN (IMPRIME AU JAPON)
CHAPTER 6 IMAGE FORMATION SYSTEM
[5]
Figure 6-668b
5 4 3
Figure 6-668c
2 1
6-78a