Canon 1130 Service Manual page 502

B. Removing the Fixing
Materials and Mounting
the Waste Toner Collection
Case
1) Remove the packaging tape, and remove the
protective sheet of the copyboard glass.
2) Peel off the tape from the metal fixing of the
scanner found on the outside of the left
cover; then, slide the metal fixing from rear
to the front and then to the left to detach.
• You will use the metal fixing when
relocating the copier; store it away to
the right of the waste toner collection
case.
3) Slide the delivery protective member to the
right; then, secure it in place to the copier's
delivery assembly with a tapping screw.
4) Open the right and left front covers, and
remove the tape and fixing material from
the lever and the like.
5) Release the lever, and slide out the
transfer unit.
6) Peel off the fixing tape, and open the
internal delivery unit.
7) Pull off the two fixing roller releasing
rolls using radio pliers.
8) Close the inside delivery unit, and slide
the transfer unit to the copier.
COPYRIGHT © 2002 CANON INC. CANON CLC1100/1130/1150/1160/1180 REV.0 MAR. 1999 PRINTED IN JAPAN (IMPRIME AU JAPON)
CHAPTER 11 INSTALLATION
Metal fixing
Figure 11-205
Delivery protective
member
Tapping screw
Figure 11-206
Inside delivery unit
Releasing rolls
Figure 11-207
11-7