4) Connect the 8-pin connector [7] of the
diagnostic device and the 8-pin connector
[8] of the copier side.
5) Secure the diagnostic device [9] to the
copier's rear cover with four screws [10].
(Use the screws that come with the unit.)
6) Remove the slack from the cable between
the copier and the diagnostic device, and
bundle the excess length of the cable on the
diagnostic device side; then, fix the bundle
in place with the harness band [11].
COPYRIGHT © 2002 CANON INC.
CANON CLC1100/1130/1150/1160/1180 REV.1 FEB. 2002 PRINTED IN JAPAN (IMPRIME AU JAPON)
CHAPTER 11 INSTALLATION
[7]
[8]
Figure 11-704
[9]
[10]
[10]
Figure 11-705
Figure 11-706
[11]
11-39