Checking Of Charging Assembly And Dustproof Glass - Canon iR5055 Series Service Manual

Chapter 2
[2]
4) Peel off the tag tape to open the fixing/delivery assembly [1].
[1]
5) Remove the 2 fixing nip pressure release screws [1]. (The removed screws
will not be used.)
[1]
[1]
6) Close the fixing/delivery assembly.
2.2.5 Checking of Charging Assembly and Dustproof
Glass
iR5065 / iR 5055 / iR5075 / iR5075N / iR5065N / iR5055N
1) Detach the feeder assembly front cover (right) [1].
- 2 screws [2]
2-8
[1]
F-2-17
F-2-18
F-2-19
2) Remove the screw [1] and the mount [2], and disconnect the connector [3].
3) While holding the front and rear sides of the transfer/separation charging
assembly [1], slide it in the [A] direction; then, remove it toward the [B]
direction.
Be careful not to cut the nylon wire by contacting the transfer/separation
charging assembly with the transfer guide.
4) Check the transfer/separation charging assembly. If any dirt or paper pow-
der is attached onto the assembly, clean it with alcohol solutions.
5) Mount the transfer/separation assembly using the steps to remove it but in
reverse.
6) Attach the feeder assembly front cover (right) with the 2 screws (use the
0015-4660
screws removed in the step 1).
Put back the fixing/feeder assembly and the duplexing unit to the original
positions (leave the fixing/feeder assembly release lever as it is).
7) Open the toner replacement cover.
8) Detach the toner replacement cover [1].
- 2 screws [2]
[2]
[1]
[2]
F-2-20
[3]
[2] [1]
F-2-21
F-2-22