CHAPTER 11 INSTALLATION
13) Press 'OK'.
14) Change the cassette size to suit the user's
needs while ATR is taking place (about 10
min).
See H. "Changing the Cassette Paper
Size."
15) Detach the hopper cap, by pulling it
slowly in horizontal direction.
If you pull on the hopper
cap at an angle, the seal of
the hopper cap will become
damaged, resulting chips
falling into the developing
assembly. Take adequate
care.
16) Press 'ADJUST'.
17) Press 'DENS'.
18) Record the data shown on the DENS
screen on the service label.
• The service label is attached behind the
Service data sheet cover inside the right
front cover. Be sure to mount the cover
after recording the data.
11-22
COPYRIGHT © 2002 CANON INC.
CANON CLC1100/1130/1150/1160/1180 REV.2 FEB. 2002 PRINTED IN JAPAN (IMPRIME AU JAPON)
Service label
Figure 11-231