Canon 1130 Service Manual page 857

CHAPTER 13 TROUBLESHOOTING
HV-TR
Adjusts the transfer high-voltage output by condition.
Level 3
HV-TR Use it to adjust the transfer high-voltage output.
TR-L1 Use it to adjust the transfer charging bias for single-
sided copying and when copying on the 1st side of a
double-sided copy using thin paper.
TR-L2 Use it to adjust the transfer charging bias when
copying on the 2nd side of a double-sided copy
using thin paper.
TR-N1 Use it to adjust the transfer charging bias for single-
sided copying and copying on the 1st side of a
double-sided copy using plain paper.
TR-N2 Use it to adjust the transfer charging bias for
copying on the 2nd side of a double-sided copy
using plain paper.
TR-T1 Use it to adjust the transfer charging bias for one-
sided copying and when copying on the 1st side of a
double-sided copy using thick paper.
TR-T2 Use it to adjust the transfer charging bias when
copying on the 2nd side of a double-sided copy
using thick paper.
TR-UT1 Use it to adjust the transfer charging bias for single-
sided copying and when copying on the 1st side of a
double-sided copying using extra thick paper.
TR-UT2 Use it to adjust the transfer charging bias when
copying on the 2nd side of a double-sided copy
using extra thick paper.
TR-S1-1 Use it to adjust the transfer charging bias for single-
sided copying and copying on the 1st side of a
double-sided copy using special paper 1.
TR-S2-1 Use it to adjust the transfer charging bias for single-
sided copying and copying on the 1st side of a
double-sided copy using special paper 2.
TR-OHP Use it to adjust the transfer charging bias when using
transparencies.
TR-POST Use it to adjust the transfer charging bias when using
postcards.
Note 1: Execute this mode upon replacement of a CPU PCB or initialization of the RAM. The settings
will be returned to standard settings, requiring you to enter the appropriate settings. Be sure to
record any new settings on the service label.
13-268
COPYRIGHT © 2002 CANON INC.
Description
CANON CLC1100/1130/1150/1160/1180 REV.0 MAR. 1999 PRINTED IN JAPAN (IMPRIME AU JAPON)
COPIER>ADJUST
Remarks
-4 to +4
Unit: 1.0 µA
-4 to +4
Unit: 1.0 µA
The copier may be adapted to
the site of installation
(temperature, humidity) by
changing its various settings.
For this mode, you will find
settings grouped into three
zones (A, B, C). On the Level
3 item screen (page 1), be
sure to adjust Level 3 items of
the appropriate zones (TEMP,
ABS-HUM).
Division by Moisture Content
Zone A: 0 to 6.17 g
Zone B: 6.18 to 18.40 g
Zone C: 18.41 g or more