Canon 1130 Service Manual page 568

Adjusting Transfer
Check the locked condition of the
transfer blade in service mode.
Is a transfer fault noted?
YES
Are there white spots
(transfer fault)?
YES
Is the fault limited to
a specific color?
YES
Are there white spots in
vertical direction?
NO
Are there vertical
lines corresponding to
separation claws?
NO
Make several
test prints. Does the
copy density decrease
(become light)?
YES
COPYRIGHT © 2002 CANON INC. CANON CLC1100/1130/1150/1160/1180 REV.0 MAR. 1999 PRINTED IN JAPAN (IMPRIME AU JAPON)
[D]
NO
NO
NO
Check the transfer blade.
YES
Check the transfer blade.
YES
Check the output of the separation
charging assembly.
NO
Check the internal/external static
eliminator.
Adjusting the Original Exposure System/Color Balance
[C]
Check the positions of the copyboard glass,
standard white plate, original scanning lamp,
reflecting plate, and mirrors, and clean them.
Check to see if the No. 1 mirror/No. 2 mirror
base is not riding over the rail.
Check to find out if the value of
ADJUST>COLOR in service mode is
identical with the value recorded on the label.
Check the contact between the CCD and the
CCD driver PCB.
Set OPTION>BODY>PASCAL in service
mode to '1'.
Execute ADJUST>CCD>CCD-ADJ in service
mode.
YES
Is the image better?
NO
Execute auto gradation correction
in user mode.
Make a copy of the CA1 Test Sheet.
Make adjustments in ADJUST>COLOR>ADJ-Y,
Is the gray scale
NO ADJ-M, ADJ-C, ADJ-K in service mode.
(especially light area)
To make copies darker, increase the setting.
of the copy good?
To make copies lighter, decrease the setting.
YES
End.
End.
13-5