Canon 1130 Service Manual page 232

4) Peel off the double-sided adhesive tape
from under the gear cover sheet.
5) Remove the three screws [5], and detach
the developing assembly lower cover [6].
The screw identified as [5a] is tightened
over the white line.
6) Remove the resin screw [7] found at the
front of the developing assembly, and
detach the electrode plate cover [8].
7) Remove the two screws [9]; then, detach
the bias wire [10] and the electrode [11] of
the developing cylinder.
COPYRIGHT © 2002 CANON INC. CANON CLC1100/1130/1150/1160/1180 REV.1 JAN. 2000 PRINTED IN JAPAN (IMPRIME AU JAPON)
CHAPTER 6 IMAGE FORMATION SYSTEM
[5]
Figure 6-637
[8]
Figure 6-638
[11]
Figure 6-639
[6] [5a]
[7]
[9] [10]
6-67