3) Peel off the transfer sheet.
4) Disconnect the connector [3], and remove
the two screws [4]; then, detach the brush
motor [5].
13. Removing the Transfer Cleaner
Push-On Brush Unit
1) Remove the transfer drum from the
transfer drum frame.
2) Remove the polishing roller unit.
3) Peel off the transfer sheet.
4) Turn the transfer drum ring so that the
dent (shown in the figure) in the rear ring
is opposite the brush.
5) Remove the two screws [1], and disconnect
the connector [2]; then, remove the transfer
cleaner push-on brush unit.
COPYRIGHT © 2002 CANON INC.
CANON CLC1100/1130/1150/1160/1180 REV.0 MAR. 1999 PRINTED IN JAPAN (IMPRIME AU JAPON)
CHAPTER 7 PICK-UP / FEEDING SYSTEM
[4]
Figure 7-869
Figure 7-870
[1]
[2]
Figure 7-871
[5]
[3]
[1]
7-99