Canon 1130 Service Manual page 940

Code
E804
1. The copier may be reset by turning its power switch off and then on when its
2. The fixing cleaning belt counter (COPIER>COUNTER>MISC>FIX-WEB
3. 'E004' is indicated on the control panel for about 1.6 sec when the error
Resetting E000, E005, E008, E020, E717, or E719
1) Start service mode, and select COPIER>FUNCTION>CLEAR>ERR (to highlight).
2) Press the OK key.
3) Turn off and then on the power switch.
E717
E717 may be prevented by temporarily disconnecting the communication line using service
mode as follows before disconnecting the copy data controller or the remot diagnostic device
connected to the copier:
1) Start service mode, and select COPIER>OPTION>IN-FACE>B-CLR (to highlight).
2) Enter '0', and press the OK key.
3) End service mode, and perform appropriate servicing.
COPYRIGHT © 2002 CANON INC.
Cause
• The operation of a fan (indicated
by detail code) is faulty.
• The CPU PCB is faulty.
• The DC driver PCB is faulty.
self diagnostic mechanism has turned on. This, however, does not apply to
E000, E005, E008, E020 (if xxE0), E717 or E719. This is to prevent possible
damage by an overheating fixing roller occurring if these errors were
designed to be reset while the thermistor has an open circuit.
in service mode) is cleared when the fixing cleaning belt is replaced.
occurs: thereafter, the power switch wil be disabled (i.e., error auto power-
off is activated).
If such is the case, turn on the power switch while the left front cover is open.
The error code may be checked by COPIER>DISPLAY>ERR in service
mode.
CANON CLC1100/1130/1150/1160/1180 REV.3 FEB. 2002 PRINTED IN JAPAN (IMPRIME AU JAPON)
CHAPTER 13 TROUBLESHOOTING
Timing of detection
0009 The delivery cooling fan
(FM11) has stopped to rotate
in error.
000A The back suction fan (FM16)
has stopped to rotate in error.
000B The power supply cooing fan
1/2 (FM9/FM13) has stopped
in error.
000C The power supply cord base
fan (FM17) has stopped to
rotate in error.
0102 The original exposure system
cooling fan 2/3 (FM14/FM15)
has stopped to rotate in error.
13-349