Removing The Atr Sensor Of The Y/M/C Developing Assembly - Canon 1130 Service Manual

1. If
2. When
4. Removing the ATR Sensor of the Y/
M/C Developing Assembly
1) Remove the Y/M/C developing assembly.
2) Remove the screw [1], and slide the
developing blade cover [2] to the right to
remove. (In the case of the Y developing
assembly, slide it to the left.)
3) Remove the four screws [3], and
disconnect the connector [4]; then,
remove the developing blade unit.
When assembling the
parts, force down the
developing blade unit, and
screw it in place.
4) Remove the three screws [5], and detach
the ATR sensor [6].
If you have replaced the
ATR sensor, be sure to
replace the developer and
select the appropriate
concentration in service
mode.
COPYRIGHT © 2002 CANON INC.
you have
disconnected
connector when
removing the Y/M/C
developing assembly,
be sure to clean the
inside of the ATR
sensor connector.
mounting
developing assembly to
the copier, be sure to
dry wipe its bias
electrode with lint-free
paper in advance to
prevent developing
faults.
CANON CLC1100/1130/1150/1160/1180 REV.2 FEB. 2002 PRINTED IN JAPAN (IMPRIME AU JAPON)
CHAPTER 6 IMAGE FORMATION SYSTEM
a
a
Force down.
[6]
[1] [2]
Figure 6-630
[3]
[4]
Figure 6-631
Force down.
Figure 6-632
[5]
Figure 6-633
6-65