Canon 1130 Service Manual page 484

6) Remove the coupling [5] and the E-ring
[6]; then, detach the pulley cover [7].
7) Remove the two screws [8] and the cable
fixing plate [9] on the left side; then,
detach the lifter cable [10] on the outside.
8) Remove the two screws [11] and the cable
fixing plate [12] on the right side; then,
detach the lifter cable [13] on the inside.
9) To remove the lifter cable [13] from the
pulley [14] on the inside, remove the two
set screws [16] of the pulley [15] on the
outside to detach the pulley [15] on the
outside in advance.
5. Removing the Lifter Cable (deck
rear)
1) Open the compartment of the deck, and
remove all paper.
2) Remove the screw, and detach the paper
rear end guide plate of the compartment.
3) Push the sensor lever [1] of the paper
supply position inside the compartment to
lower the lifter so that the left and right
holes in the compartment side plate and
the left and right holes in the lifter match;
then, insert two long screwdrivers [2]
through the holes. At this time, try
matching the top face of the lifter against
the scribe line on the compartment left
side plate to facilitate the work.
COPYRIGHT © 2002 CANON INC. CANON CLC1100/1130/1150/1160/1180 REV.1 FEB. 2002 PRINTED IN JAPAN (IMPRIME AU JAPON)
CHAPTER 10 PAPER DECK
[16] [10]
[8] [9] [14] [15]
Figure 10-330
[1]
Figure 10-331
[13]
[12] [11]
[7]
[6]
[5]
[2]
10-31