CHAPTER 7 PICK-UP / FEEDING SYSTEM
6) Let the transfer drum sheet drop on its
own weight, and remove the backing
paper from both sides of the sheet.
7) Without holding the transfer drum sheet,
turn the front side of the transfer ring to
wrap it around the transfer drum.
After wrapping the transfer
drum sheet around the
transfer drum, check the
gap between the leading
edge and the trailing edge
of the sheet; make sure it is
0±1.5 mm. If not, go back
to step 5), and make sure
that the sheet is horizontal,
and start over.
7-92
COPYRIGHT © 2002 CANON INC.
CANON CLC1100/1130/1150/1160/1180 REV.2 FEB. 2002 PRINTED IN JAPAN (IMPRIME AU JAPON)
Figure 7-847
Figure 7-848
Leading edge of sheet
Trailing edge of sheet
0±1.5 mm or less
Figure 7-848a
Figure 7-848b