Mounting The Drum - Canon 1130 Service Manual

CHAPTER 9 EXTERNALS / AUXILIARY MECHANISMS
11) Remove the static eliminator brush.
12) Disconnect the two connectors [12], and
remove the seven screws [13]; then,
detach the drum motor assembly [14]
together with the fixing plate.
13) Remove the four screws, and detach the
drum motor from the mounting plate.
2. Mounting the Drum Motor
Assembly
When the drum motor assembly is
removed from the copier, be sure to adjust its
position using the drum shaft position tool
(FY9-3045) when mounting it back to
eliminate any discrepancy.
1) Slide out the photosensitive drum unit
from the copier.
2) Remove the six screws [1], and detach the
photosensitive drum butting block [2]
(front, rear);
photosensitive drum [3] from the
photosensitive drum frame unit [4].
3) Insert the photosensitive drum frame unit
[5] in the copier, and mount it with three
screws [6].
9-30
COPYRIGHT © 2002 CANON INC.
then, detach the
CANON CLC1100/1130/1150/1160/1180 REV.2 DEC. 2000 PRINTED IN JAPAN (IMPRIME AU JAPON)
[13] [13] [12]
[13] [13]
Figure 9-730
[4]
[1] [2]
Figure 9-731
[6] [5] [6]
Figure 9-732
[13]
[14]
[2] [1]
[3]
[6]