Adjusting The S-B Gap; Replacing The Developer - Canon 1130 Service Manual

CHAPTER 6 IMAGE FORMATION SYSTEM

6. Adjusting the S-B Gap

If you have replaced the developing blade,
make adjustments using the S-B gap gauge
(FY9-3044). See the following for the S-B gap
of each sleeve:
Developer color
Yellow
Cyan
Magenta
Black
Insert two gauges (see the guide above for
each color; on both ends) into the gaps
between the developing blade and the sleeve,
and secure the developing blade in place.
If
developing assembly at an
angle, its gear at the rear
can
photosensitive drum.
When
developing assembly, be
sure that it is horizontal in
relation to the rails, and
take extra care not to bring
it in contact with the drum.
Further, when inserting the
black
assembly, be sure that it
will not ride over the rails.

7. Replacing the Developer

1) Open the hopper unit fully.
2) Put a plastic bag [1] against the discharge
opening. (An appreciable amount of
developer will fall out.)
3) Remove the cap [2] of the discharge
opening found at the lower front of the
developing assembly whose developer is
to be replaced.
6-70
COPYRIGHT © 2002 CANON INC.
S-B gap
0.62mm
0.74mm
0.74mm
0.48mm
you insert the
damage the
inserting the
developing
CANON CLC1100/1130/1150/1160/1180 REV.3 FEB. 2002 PRINTED IN JAPAN (IMPRIME AU JAPON)
Figure 6-646
Figure 6-647
[2]
[1]