Canon 1130 Service Manual page 233

CHAPTER 6 IMAGE FORMATION SYSTEM
8) Remove the grip ring [12], washer [13],
butting roll [14], and spacer [15].
When assembling the part,
be sure to leave a gap of
0.2 ±0.1 mm between the
roll [4] and the washer
[13].
9) Remove the E-ring [16], grip ring [17],
two gears [18], bearing [19], and sleeve
slider [20] at the rear of the developing
assembly.
When assembling the part,
be sure there is NO gap
between the gear [18] and
the grip ring [19].
10) Remove the two screws [21] at the rear of
the developing assembly, and detach the
gear cover [22].
6-68
COPYRIGHT © 2002 CANON INC.
[20]
[16]
CANON CLC1100/1130/1150/1160/1180 REV.2 FEB. 2002 PRINTED IN JAPAN (IMPRIME AU JAPON)
[15] [14] [13] [12]
Figure 6-640
[19]
[17] [18]
Figure 6-641
[22]
Figure 6-642
[21]