Canon 1130 Service Manual page 227

CHAPTER 6 IMAGE FORMATION SYSTEM
4. Replacing the Wire Cleaning Pad of
the Primary Charging Assembly
1) Remove the primary charging assembly.
2) Remove the two screws [1], and detach
the shielding plate [2].
3) Pick the cleaning pad [3] to remove.
Keep the following in
mind for cleaning and
checking the primary
charging assembly:
• Make a thorough check
to be sure that the block
(front, rear) is free of
melting by leakage,
thermal deformation,
caking, yellowing, or the
like.
If a fault is found,
replace it with a new part
without delay.
• Be sure to check the
inside of the block
(front, rear) as well as
the outside.
• Be sure to provide
scheduled servicing and
replacement
prescribed intervals.
6-62
COPYRIGHT © 2002 CANON INC.
at
CANON CLC1100/1130/1150/1160/1180 REV.2 FEB. 2002 PRINTED IN JAPAN (IMPRIME AU JAPON)
[2]
[1]
[1]
Figure 6-623
[3]
Figure 6-624