Canon iR C3200 Series Service Manual page 117

15) Ring the service station for initial settings of the controller. (Upon arrival, LED 4 [21] (red) will start to flash.)
16) Ring the service station, and find out if initial settings have been made. If the setup has failed, initialize the RAM
once again (steps 11) through 13)) to start over.
Be sure to check with the service station once again to make sure that the controller settings are correct.
17) Check to make sure that the controller may be used to call up the PC at the service station. Press the push switch
(SW4) [16] on the PCB so that LED6 [22] (red) goes ON. The LED goes OFF when the transmission ends
successfully; otherwise, it will start to flash.
When the push switch (SW4) [16] is pressed while LED6 [22] is flashing, a transmission will be initiated once again.
If the push switch (SW1) [23] is pressed while LED6 [22] is flashing, the ongoing transmission will be cancelled.
18) Check to make sure that the communication with its host machine is normal. Connect the host machine's power
plug, and turn on the power switch; then, check to make sure that LED2 [24] (orange) starts to flash.
LED1 LED2 LED3
2 6
BAT1
1 1
SW3
SW2
LED5
SW4
LED6
LED4
IC6
SW1
[21]
CN3 CN2
F-2-109
LED1 LED2 LED3
2 6
BAT1
1 1
SW2 SW3
LED5
SW4
[16]
LED6
LED4
IC6
[22]
SW1
[23]
CN3 CN2
F-2-110
[24]
LED1 LED2 LED3
2 6
BAT1
1 1
SW3
SW2
LED5
SW4
LED6
LED4
IC6
SW1
CN3 CN2
F-2-111
1
2
CN4
1
2
CN4
1
2
CN4
Chapter 2
2-41