Pascal Setting - Canon iR C3200 Series Service Manual

Chapter 2
2) Change the setting to make adjustments.
(A change by '1' will cause a shift of 0.1 mm; a higher value will move the image toward the leading edge of the
paper.)
- Adjusting the Image Area (non-image width)
1) Make the following selections in service mode: COPIER>ADJUST>BLANK>BLANK_T/L/B/R.
2) Change the settings to make adjustments. (An increase by '24' will increase the non-image width by about 1 mm;
the setting may be between 0 and 1000.)
- If a line is found in the output image, go through the following:
1) Make the following selections in service mode: COPIER>CCD>SH-PS-ST.
2) Press the OK key so that the indication on the screen will change to 'ACTIVE' indicating that the machine is
executing automatic adjustment of shading position.
- If 'OK' is indicated on the screen,
3) See that auto adjustment has ended.
- If 'NG' is indicated on the screen,
3) Make the following selections in service mode: COPIER>ADJUST>ADJ-XY>ADJ-S.
4) Change the setting to adjust the shading position.

2.5.2 PASCAL Setting

1) Make the following selections in service mode: COPIER>OPTION>BODY>PASCAL.
2) Check to make sure that the setting is '1'.
3) Press the Reset key several times to end service mode.
4) Make the following selections in user mode: adjust/clean>auto gradation correction.
5) Select the appropriate type of paper, and press [full correction].
6) Place the test print 1 output on the copyboard glass, and have the machine read it.
7) Press [test print 2] to generate test print 2.
8) Place the test print 2 output on the copyboard glass, and have the machine read it.
9) Press [test print 3] to generate test print 3.
10) Place the test print 3 output on the copyboard glass, and have the machine read it.
When all work is done, turn the adjuster on the bottom of the pedestal to secure the machine in place.
2-28
L1
Image
An increase in the value of
REGIST will move the image
toward the leading edge of the paper.
F-2-86
0000-4380