Installing The Ne Controller-A1 - Canon iR C3200 Series Service Manual

Chapter 2

2.8 Installing the NE Controller-A1

2.8.1 Installing the NE Controller-A1

Keep the following in mind when installing the controller to its host machine:
1. Be sure that the work complies with the laws and regulations of the country of installation.
2. Be sure that its host machine has properly been installed before starting the work.
3. Be sure to disconnect its host machine's power plug before starting the work.
4. Be sure to identify the screws by type (length, diameter) and location.
5. Be sure to prepare the appropriate settings data on a PC at the service station.
1) Remove the 2 screws [2], and detach the upper cover [1].
2) Connect the connector [3] of the power supply unit to the connector [4] as shown.
3) Remove the 6 screws [5], and detach the face plate [3] of the host machine's upper rear cover.
2-34
[1]
[2]
F-2-95
[4]
[3]
F-2-96
[2]
0000-8506