CAUTION:
allow the fastened loops of a cable to dangle, which stresses the cable at the
fastening point.
Connecting the SRX5400 to Power
IN THIS SECTION
Tools and Parts Required for SRX5400 Services Gateway Grounding and Power Connections | 198
Grounding the SRX5400 Services Gateway | 199
Connecting Power to an AC-Powered SRX5400 Services Gateway | 200
Powering On an AC-Powered SRX5400 Services Gateway | 202
Connecting Power to a DC-Powered SRX5400 Services Gateway | 203
Powering On a DC-Powered SRX5400 Services Gateway | 206
Powering Off the SRX5400 Services Gateway | 207
Tools and Parts Required for SRX5400 Services Gateway Grounding and
Power Connections
To ground and provide power to the services gateway, you need the following tools and parts:
Phillips (+) screwdrivers, numbers 1 and 2
2.5-mm flat-blade (–) screwdriver
7/16-in. hexagonal-head external drive socket wrench, or nut driver, with a torque range between
23 lb-in. (2.6 Nm) and 25 lb-in. (2.8 Nm) tightening torque, for tightening nuts to terminal studs on each
power supply on a DC-powered services gateway.
Wire cutters
Electrostatic discharge (ESD) grounding wrist strap
Do not let fiber-optic cables hang free from the connector. Do not
198