Installation Procedure (Front Push) - IBM 3 User Manual

thumbs (1) until the tractor locks in the fully extended position (2).

Installation Procedure (Front Push)

To install the forms tractor in the Front Push position:
1. The power switch is located on the lower left side of the printer. Ensure that
the printer is powered off (O) before removing or installing forms tractors.
2. Open the front tractor cover to its locked position.
CAUTION:
<2-52> The paper feed motor may get hot during operation. Be careful when
removing or installing the tractor unit.
Chapter 17. Setting Up Forms Paths
217