Perforation Skipping - IBM 3 User Manual

The LPI and the page length determine the MPL. Multiply the lines per inch by the
page length to determine the appropriate MPL:
For example, if LPI=6 and page length=254 mm (10 in.), then
Note: This parameter can be overridden by the computer.
To change or check the MPL, follow these steps:
1. Press Menu.
2. Press Scroll or Scroll until the printer displays
3. Press Enter.
4. Press Scroll or Scroll until the printer displays
5. Press Enter to display the current value.
6. Press Scroll or Scroll until the desired value for MPL is displayed.
7. Press Enter.
8. Press Start or Return to exit the Menu. See "Exiting the Configuration Menu"

Perforation Skipping

Use this parameter to create a bottom margin on your printed page, if the host
data stream does not create a bottom margin.
The range of values is 0 to 879 lines, at 8 lpi. The default value is 0.
To change of check perforation skipping, follow these steps:
120
4247 Model 003 User's Guide
MPL = LPI x page length (in inches)
MPL = 6 x 10
MPL = 60
CONFIGURATION MENU
Parallel Configuration
Parallel Configuration
Maximum Page Length
An asterisk (*) will be displayed in front of the selected value.
on page 55.