Loading Forms (Rear Push) - IBM 3 User Manual

11. Close the front tractor cover.
12. Press Load/Eject to feed the forms.

Loading Forms (Rear Push)

Note: If you have installed an ASF unit and you now want to install the rear
tractor, you must first power off (O) the printer, remove the ASF stacker, and
then reinstall the stacker after completing installation of the rear tractor.
To load forms in the rear push position:
1. Press Park/Path. The printer displays
091 FANFOLD PARK
TEAR OFF AT OUTPUT AND PRESS PARK
2. Press Stop and perform the action requested on the operator panel display.
3. Press Park/Path to back the forms below the print line.
4. Press Park/Path again to change the forms path on the operator panel display
to Rear.
5. Open the rear tractor paper door in the back of the printer.
6. Open the top cover and the forms guide.
7. Unlock the locking levers on the tractors. Move the right tractor to the
extreme right.
Chapter 17. Setting Up Forms Paths
229