Printer Compatibility 8 (Automatic Function After End Of Oilc Job) - IBM 3 User Manual

10. Press Start or Return to exit the Menu. See "Exiting the Configuration Menu"

Printer Compatibility 8 (Automatic Function After End of OILC Job)

You can set this value to:
Standard (Default)
Alternate
Note: The printer performs a partial reset to put any change to this parameter
To change or check the automatic function after end of OILC job, follow these
steps:
4. Press Scroll or Scroll until the printer displays
Coax Configuration
Printer Compatibility
5. Press Enter.
6. Press Scroll or Scroll until the printer displays
Printer Compatibility
7 (Auto at EOB)
7. Press Enter to display the current value.
8. Press Scroll or Scroll until the desired value for automatic function after
end of print buffer is displayed.
9. Press Enter.
An asterisk (*) will be displayed in front of the selected value.
on page 55.
The printer will execute an automatic New Line function at the end of an
OILC (Operator Initiated Local Copy) job.
The printer will execute an automatic Form Feed function at the end of an
OILC (Operator Initiated Local Copy) job, unless a Form Feed was the last
function executed.
value into effect when you exit the Configuration Menu with Start or
Return. Buffered data will be lost.
1. Press Menu.
2. Press Scroll or Scroll until the printer displays
CONFIGURATION MENU
Coax Configuration
3. Press Enter.
4. Press Scroll or Scroll until the printer displays
Coax Configuration
Printer Compatibility
5. Press Enter.
Chapter 8. Coax Configuration
105