Printer Compatibility 6 (Init) - IBM 3 User Manual

10. Press Start or Return to exit the Menu. See "Exiting the Configuration Menu"

Printer Compatibility 6 (Init)

You can set the printer to detect the Init signal and perform a partial reset when
active or to ignore the signal. You can set this value to:
Enabled (Default)
Disabled
To change or check the Init signal, follow these steps:
128
4247 Model 003 User's Guide
4. Press Scroll or Scroll until the printer displays
Parallel Configuration
Printer Compatibility
5. Press Enter.
6. Press Scroll or Scroll until the printer displays
Printer Compatibility
5 (FF Suppression)
7. Press Enter to display the current value.
8. Press Scroll or Scroll until the desired value for Form Feed Suppression is
displayed.
9. Press Enter.
An asterisk (*) will be displayed in front of the selected value.
on page 55.
Init signal detection disabled. No action occurs when Init is activated.
Init signal detection enabled. When Init is activated, the printer performs a
partial reset.
1. Press Menu.
2. Press Scroll or Scroll until the printer displays
CONFIGURATION MENU
Parallel Configuration
3. Press Enter.
4. Press Scroll or Scroll until the printer displays
Parallel Configuration
Printer Compatibility
5. Press Enter.
6. Press Scroll or Scroll until the printer displays
Parallel Configuration
6 (Init)
7. Press Enter to display the current value.
8. Press Scroll or Scroll until the desired value for Init is displayed.
9. Press Enter.
An asterisk (*) will be displayed in front of the selected value.