10. Press Start or Return to exit the Menu. See "Exiting the Configuration Menu"
Alarm Control
You can set the audible printer alarm to either of the following values:
v Enabled (Default)
v Disabled
Note: Pressing Set Top of Form, and some unit check conditions sound the alarm,
To change or check the alarm control, follow these steps:
1. Press Menu.
2. Press Scroll or Scroll until the printer displays
3. Press Enter.
4. Press Scroll or Scroll until the printer displays
5. Press Enter to display the current value.
6. Press Scroll or Scroll until the desired value for Alarm Control is displayed.
7. Press Enter.
8. Press Start or Return to exit the Menu. See "Exiting the Configuration Menu"
Override Host Parameters
Paper Source
This parameter allows the printer to accept or ignore (override) the Paper Source
selection commands that are sent by the host data stream. You can set Paper
Source to:
Disabled (Default)
5. Press Enter.
6. Press Scroll or Scroll until the printer displays
Printer Compatibility
9 (20 CPI)
7. Press Enter to display the current value.
8. Press Scroll or Scroll until the desired value for 20 CPI mode is displayed.
9. Press Enter.
An asterisk (*) will be displayed in front of the selected value.
on page 55.
even if the alarm is disabled.
CONFIGURATION MENU
Parallel Configuration
Parallel Configuration
Alarm Control
An asterisk (*) will be displayed in front of the selected value.
on page 55.
The printer accepts and processes commands received from the host data
stream for paper source selection.
Chapter 9. Parallel and Serial Configuration
131