Printer Compatibility 5 (Form Feed Suppression) - IBM 3 User Manual

To change or check the automatic carriage return after a line feed setting, follow
these steps:
10. Press Start or Return to exit the Menu. See "Exiting the Configuration Menu"

Printer Compatibility 5 (Form Feed Suppression)

This parameter is displayed when emulation mode is set to 4247, 4202 III XL, or
2381 Personal Printer.
You can set the printer to suppress host form feed commands or to honor all host
form feeds. You can set this value to:
Disabled (Default)
Enabled
Note: Operator panel form feeds are not affected.
To change or check form feed suppression, follow these steps:
1. Press Menu.
2. Press Scroll or Scroll until the printer displays
CONFIGURATION MENU
Parallel Configuration
3. Press Enter.
4. Press Scroll or Scroll until the printer displays
Parallel Configuration
Printer Compatibility
5. Press Enter.
6. Press Scroll or Scroll until the printer displays
Printer Compatibility
4 (Auto CR on LF)
7. Press Enter to display the current value.
8. Press Scroll or Scroll until the desired value for Automatic Carriage Return
on Line Feed is displayed.
9. Press Enter.
An asterisk (*) will be displayed in front of the selected value.
on page 55.
All form feed commands from the host are honored.
Form feed commands from the host are ignored if the printer is at top of
form and no data for the page was received.
1. Press Menu.
2. Press Scroll or Scroll until the printer displays
CONFIGURATION MENU
Parallel Configuration
3. Press Enter.
Chapter 9. Parallel and Serial Configuration
127