Emulation Mode - IBM 3 User Manual

1. Press Menu.
2. Press Scroll
3. Press Enter.
4. Press Scroll
5. Press Enter to display the current value.
6. Press Scroll
7. Press Enter.
8. Press Start or Return to exit the Menu. See "Exiting the Configuration Menu"

Emulation Mode

You can set Emulation Mode to the following values:
v 4247 (Default)
v 2381 Personal Printer
v 4202 Proprinter III XL
v Epson-FX
Note: The printer performs a partial reset to put any change to this parameter
To change or check the emulation mode, follow these steps:
1. Press Menu.
2. Press Scroll or Scroll until the printer displays
3. Press Enter.
4. Press Scroll or Scroll until the printer displays
5. Press Enter to display the current value.
6. Press Scroll or Scroll until the desired value for Emulation Mode is
7. Press Enter.
8. Press Start or Return to exit the Menu. See "Exiting the Configuration Menu"
or Scroll . The printer displays
CONFIGURATION MENU
Parallel and Serial Configuration
or Scroll . The printer displays
Parallel and Serial Configuration
Perforation Skipping
or Scroll
displayed.
An asterisk (*) will be displayed in front of the selected value.
on page 55.
value into effect when you exit the Configuration Menu with Start or
Return. Buffered data will be lost.
CONFIGURATION MENU
Parallel Configuration
Parallel Configuration
Emulation Mode
displayed.
An asterisk (*) will be displayed in front of the selected value.
on page 55.
until the desired Perforation Skipping value is
Chapter 9. Parallel and Serial Configuration
121