Automatic Restore - IBM 3 User Manual

5. Press Enter to display the current value.
6. Press Scroll or Scroll until the desired value for the Automatic Eject is
displayed.
7. Press Enter.
An asterisk (*) will be displayed in front of the selected value.
8. Press Start or Return to exit the Menu. See "Exiting the Configuration Menu"
on page 55.

Automatic Restore

This parameter is displayed for the Front Push or Rear Push forms path. You can
set the printer to perform an automatic load without pressing Load/Eject.
You can set this value to:
Disabled (Default)
No automatic load. The Load/Eject is required to load forms.
Data An automatic load occurs each time a new print job is received.
Timer (10 to 50 seconds)
An automatic load with a fixed timeout value. When forms are ejected, a
load function is performed after a timeout. The timeout value can be 10
seconds, 20 seconds, 30 seconds, 40 seconds, or 50 seconds.
To change or check the automatic restore, follow these steps:
1. Press Menu.
2. Press Scroll or Scroll until the printer displays
CONFIGURATION MENU
Printer Setup
3. Press Enter.
4. Press Scroll or Scroll until the printer displays
Printer Setup
Automatic Restore
5. Press Enter to display the current value.
6. Press Scroll or Scroll until the desired value for Automatic Restore is
displayed.
7. Press Enter.
An asterisk (*) will be displayed in front of the selected value.
8. Press Start or Return to exit the Menu. See "Exiting the Configuration Menu"
on page 55.
The Automatic Restore function can be enabled regardless of the status of the
Automatic Eject function. Automatic Restore can be enabled even if Automatic
Eject is not enabled.
151
Chapter 10. Printer Setup