IBM 3 User Manual page 34

1. Before attaching the twinax cable, set the printer address. If your desired
24
4247 Model 003 User's Guide
printer address is 0, go to Step 2 on page 25. If your desired printer address is
not 0, see the following table for the valid values and follow Steps 1a through
1k on page 25 to change the value. If you do not know what to assign for the
printer address, check with your system operator.
If Desired
Address Is: Set:
0 000
1 001
2 002
3 003
4 004
5 005
6 006
To set the printer address, follow these steps:
a. Power on (|) the printer.
b. Wait until the message IBM 4247 appears, all segments of the LCD on the
operator panel display are lighted, and the printer has stopped all motion.
The printer then displays:
DIAGNOSTICS IN PROGRESS
PLEASE WAIT
READY
Twinax Front
and this error message is displayed:
015 COMMUNICATIONS CHECK
CHECK CABLE
c. Press Menu.
d. Press Scroll or Scroll
CONFIGURATION MENU
Twinax Configuration
e. Press Enter.
f. Press Scroll or Scroll
Twinax Configuration
Printer Address
g. Press Enter. The printer displays:
Printer Address
* 000
h. Press Scroll or Scroll
Shown when Setting
Printer Address:
Printer Address=0
Printer Address=1
Printer Address=2
Printer Address=3
Printer Address=4
Printer Address=5
Printer Address=6
<A>
until the printer displays:
until the printer displays:
until the printer displays the desired address.