IBM 3 User Manual page 318

2. Press Load/Eject.
If Backup has been disabled for the current path, or the current path is the
Push-Pull path or a cut-sheet path, the printer must Eject forms instead of Park. In
this case, the message '092 FANFOLD EJECT ...' is displayed on the operator panel
when a path switch is being requested. Tear off the forms where they enter the
printer, and press Load/Eject.
This is an informational message. The printer displays this message after you press
Load/Eject to eject the forms when Continuous Forms Eject Mode is set to Delayed
Eject. See Chapter 10, "Printer Setup".
The printer displays
after the forms are ejected.
Recovery:
1. Press Stop.
2. Change the "Print Language" value in the Configuration Menu category to
Recovery
1. Close the printer top cover.
2. Press Start to make the printer ready.
This message is displayed when Menu is pressed when the Menu Lock feature is
enabled.
Recovery:
1. Contact your system programmer.
This message is displayed when a HOST timeout occurs.
Recovery:
308
4247 Model 003 User's Guide
093 EJECT PENDING
003 FORMS EJECTED
PRESS LOAD
095 OPTION NOT AVAILABLE
CHANGE PRINT LANGUAGE
something other than OCR-A or OCR-B.
096 NOT READY
COVER OPEN
097 FUNCTION NOT AVAILABLE
MENU LOCKED
098 HOLD PRINT TIMEOUT
PRESS LOAD