IBM 3 User Manual page 306

Rear Pull:
1. Press Stop.
2. Load forms for the Rear Pull forms path. See Chapter 17, "Setting Up Forms
3. Press Start.
If the message displays again, tune the sensor. See Sensor Tune in Chapter 11,
"Printer Adjustments".
If the message still displays, call for service.
Push-Pull:
1. Press Stop.
2. Load forms in the Push-Pull forms path. See Chapter 17, "Setting Up Forms
3. Press Start.
If the message displays again, tune the sensor. See Sensor Tune in Chapter 11,
"Printer Adjustments".
If the message still displays, call for service.
Recovery:
10. If the message displays again, perform the actions under "Forms buckle, twist,
If the message displays again, clean the tractor sensors with a soft, clean cloth.
If the message still displays, call for service.
296
4247 Model 003 User's Guide
Paths".
Paths".
002 FORMS JAMMED FRONT TRACTOR
CLEAR JAM AND RELOAD FORMS
1. Press Stop to silence the alarm (press Stop twice on a coax-attached printer.)
The message remains in the display.
2. Clear the jammed or torn form. If paper is difficult to remove from the
printhead area, note the setting on the AFTA wheel. Rotate the AFTA wheel to
a higher number to clear the jam, and return the AFTA wheel to the original
setting.
3. Reload forms.
4. Press Stop.
5. If you are printing in the Rear Pull or Push-Pull forms path, check to ensure
the rear tractor paper door is opened for the forms to exit through.
6. Ensure the metal deflector on the forms guide and the paper bail are in the
correct positions. For the correct positions, see "Installing the Forms Tractor"
for the forms path you are currently using in Chapter 17, "Setting Up Forms
Paths".)
7. Close the tractor covers and the top cover.
8. Press Start. The printer becomes not ready.
9. Press Load/Eject or Start to load forms and restart the print job.
jam, or tear." (See "Problem List Index" on page 313.)
003 FORMS EJECTED
PRESS LOAD