Installing Optional Attachment Card - IBM 3 User Manual

Installing Optional Attachment Card

Use this procedure if you received an optional attachment card with your printer.
Do not remove the attachment card from the protective package until you:
v Read the information in "Handling Attachment Card" on page 6
v Are instructed to remove the card from the protective package
The 4247 printer arrived with a parallel interface port permanently installed at the
rear of the printer. You can install an optional attachment card, positioned above
the parallel port.
1. Ensure the printer is powered off (O).
2. Open the shipping box that contains the attachment card and remove only the
3. From above the parallel port at the rear of the printer, use the screwdriver to
Figure 3. Removing Attachment Card Cover Plate - Rear of Printer
4. Use the information in "Handling Attachment Card" on page 6 as you remove
5. Position the attachment card to align with the rails of the slot. Slide the card
screwdriver.
remove the two screws to remove the plate that covers the attachment card slot.
These screws are not captive, and will fall away from the plate. Retain the plate
and screws if you anticipate future operation of the printer with no attachment
card installed in the slot.
the attachment card from its shipping box and from the protective package.
into place, and press against the plate of the card to ensure good physical
contact.
Chapter 1. Getting Started
7