Firmware Information - IBM 3 User Manual

Factory Defaults
If a custom set is identical to the factory defaults, it will be identified as Factory
Defaults. If the only change from factory defaults is a non-custom set parameter
value (a value that stays the same no matter which custom set you are using, such
as Twinax Address), only the first custom set will be identified as In Use. The
other custom sets will be shown as factory defaults.
To print the custom sets:
1. Press Stop to make the printer not ready.
2. Press Test.
3. Press Scroll or Scroll until the printer displays
4. Use Enter or Start to begin the test. The printout will list all the custom sets.
5. Press Cancel Print to make the printer ready, or Return to make the printer not

Firmware Information

You can print information to verify your printer model number and the microcode
level installed in your printer. You will need this information if problems occur
with your printer and you need to contact your service representative. See
Figure 19 for a sample printout of a printer with twinax attachment.
To check the Firmware Information:
1. Press Test.
2. Press Scroll
3. Press Enter or Start to begin the test.
4. Press Cancel Print to make the printer ready or Return to make the printer not
Firmware Information
Printer Machine Type and Model:
IBM P/N xxxxxxx : Controller Code
Figure 19. Sample Firmware Printout
A custom set that is identical to one of the factory defaults.
4247 OPERATOR PRINT TESTS
Print Custom Sets
The Ready indicator is lighted and the Print Test prints. The printout is
complete when the Ready indicator is no longer lighted.
ready.
or Scroll
4247 OPERATOR PRINT TESTS
Firmware Information
The Ready indicator goes on and printing begins. The firmware printout is
complete when the Ready indicator goes off.
ready (see "General Test Instructions" on page 273).
Generator Code
Twinax SCS/IPDS Code Version x.xx
until the printer displays
4247-003
Version x.xx
Version x.xx
Chapter 18. Using the Operator Print Tests
281